MAC MCS2000 Betriebsanleitung PDF herunterladen (Seite 7)

MCS2000 by MacAllister

Getting started...

Before you start

Replace the cover (9) and >

slightly tighten the locking wheel

(7) (Fig. 7, b). Do not tighten

the locking wheel completely;

saw chain tensioning is required

rst.

9 7

Fig. 7

NOTE: The saw chain (3) has not yet been tensioned.

Tension the chain as described under “Saw chain

tensioning”. After operating the product for approximately

1 hour, adjust the chain tension again.

Saw chain tensioning

Always check the saw chain tension before use, after rst cuts

and regularly during use, approximately every ve cuts. After

initial operation, new chains can lengthen considerably. This is

normal during the break-in period and the interval between future

adjustments will lengthen quickly.

WARNING! Unplug the product from the power source

before adjusting the saw chain tension!

The cutting edges of the saw chain are sharp. Always

wear protective gloves when handling the chain!

Always maintain proper chain tension! A loose chain

increases the risk of kickback! A loose chain may jump out

of the guide bar groove! This may injure the operator and

damage the chain! A loose chain will cause rapid wear to

the chain, guide bar and sprocket!

Tensioning the chain too tightly will overload the motor and

cause damage, and insufcient tension can cause chain

derailing, whereas a correctly tightened chain provides

the best cutting characteristics and prolonged working life!

The chain life mainly depends upon sufcient lubrication

and correct tensioning!

MNL_MCS2000_DFT_GB_V06_111108.indd 7 11/8/11 5:11:08 PM

1 2 3 4 5 6 7 8 9 10 11 12 ... 46 47

Keine Kommentare

MAC MCS2000 Betriebsanleitung Seite 7